- Contact Person : Mr. Yan Henry
- Company Name : Shenzhen Trainertec Electronic Co., Ltd.
- Tel : 86-0755-66827928
- Fax : 86-0755-33101228
- Address : Guangdong,ShenZhen,Long Hua
- Country/Region : China
Ultrasonic bark control
Main Feature:
Uses ultrasonic sound to deter unwanted barkingDetects the sound of barking up to 15 meters4 levels of operation including test mode , 3 range levels , On/Off switchDurable and weatherproof for outdoor use.LED power indicationUnit size: L*W*H= 99*64*115.5 MMPowered by 9-Volt batter
How to operate the Ultrasonic Bark Collar
1. Installation and Setup
The Ultrasonic Bark Collar should be placed facing the dog and within range of the dog . It should be positioned at a height of no more than 1.5 meters . It can be place in a tree , hanging from a pole , on a fence post, etc . For best results , the area between the Ultrasonic Bark Collar and the dog should be free of any large obstacles.
2. Change battery
The Ultrasonic Bark Collar utilizes a replaceable 9-Volt battery . The battery is good , The green LED flash 1 time per 5 seconds . If the battery is low , The LED flash frequently . If there is no LED light it is time to change the battery . Open the battery door to replace the battery .
3.Modes of Operation
.Begin use of the Ultrasonic Bark Collar with Low Range (“1”) mode , if the dog does not respond , increase to the Medium Range (“2”) .
.IF the dog does not respond to the Medium Range (“2”) , increase to High Range (“3”) .
.Turn to the Test mode to verify the Ultrasonic Bark Collar work properly .
4. Test the Ultrasonic Bark Collar
.Turn the Mode Switch to “T”
.Hold the unit with the Indicator Light towards you .The unit should be arms length away from your mouth
.In order to activated the unit , say “Woof” loudly towards the Microphone
.The LED light will flash red and there will be an audible sound to indicate that it is functioning properly .
.Return the Mode Switch to Low Range “1” before you begin using the ultrasonic bark collar
Ultrasonic bark control